Lipo Heating Case

  • Outer dimensions: 460 x 355 x 170 mm
  • Internal dimensions: 420 x 305 x 70 mm
  • 3 x 12V – 12 Watt heating elements
  • 3A power supply
  • 2 x Fan for proper heating air circulation
  • Heating up to 70° C

Control of heating elements works through a digital thermometer which is attached at the outside. As soon as the settled temperature falls below 1° C, the internal switch turns on automatically. The case is fully build up with insulation material, the bottom plate is doubled walled.


The case is powered by a 3S Lipo, you can choose either the internal connector or the two 4mm connection at the outside of the case.

The cables at the inside are the temp. sensor and the power supply connector to the 3S Lipo.


With the purchase of the lipo heating case you confirm that you have read, understood and accepted following safety indications:

Do not operate both internal and external power supply at the same time. Significant risk of short circuit!

By using the external power supply connector please beware that the conductor (red cable) of the internal connector has a

protective isolation cap on it. Significant risk of short circuit!

The interior aluminum coated isolation of the case is a conductor. Please always beware that the Lipo connectors in the inside of the case have protective isolator caps on them. Significant risk of short circuit, fire hazard!!

The cases do not have a voltage regulator. If using a 3S Lipo please always check the voltage in order to avoid deep discharge of the lipo.The lipo heating case is not a fire protection

case!The case should be powered only in a horizontal position.



Standard Lipo Heating Case 169,00€

FULL SET Lipo Heating Case 259,00€

Full Set Includes the following:

  • Soldered XT-60 internal connector
  • Power supply unit 12V, 5A with suitable connectors
  • Cigarette lighter cable with power switch and suitable connectors
  • SLS XTRON 3S 5000 mAh with suitable XT-60 connectors

169,00 €

  • verfügbar / available
  • 2 Wochen Lieferzeit / 2 weeks lead time1